---
title: "Dishwasher will not fill"
description: "Miele dishwasher will not fill — the machine starts, waits and stops. Miele publishes several separate conditions for this and they point at four things…"
url: "https://mielemiami.support/symptoms/dishwasher-not-filling/"
date_modified: "2026-08-22"
---


# Miele dishwasher will not fill

### The fastest diagnosis is the code

Open the tap fully, then check the inlet filter where the hose screws onto it — with the machine unplugged and the tap closed, because that plastic housing contains an electrical valve. In this water that filter is the single most common cause and almost nobody has ever cleaned it.

### Four causes, three of them outside the machine

The manufacturer lists them in order and so do we: the tap, the inlet filter at the screw connection, a kinked hose, and flow pressure below the 7.25 psi minimum. Only the fourth is plumbing you cannot see, and only after all four does this become a valve.

### Why the inlet filter matters more here

The interval this machine assumes for that filter was written for softer water than Miami-Dade, Broward and Palm Beach supply. It loads earlier, and because it sits at the tap rather than inside the appliance, almost nobody has ever looked at it.

Not fully open, usually after work under the sink. The manufacturer lists it first for a reason.

The inlet filter

Inside the screw connection at the tap. It loads with scale faster here than the interval assumes.

A kinked hose

Behind a machine that has been pushed back into its opening.

Flow pressure below the minimum

The maker names 7.25 psi. A machine on a shared line can be under it at certain times of day.

The cycle starts and no water arrives

What it usually means

A cycle that stops early with dry dishes

A number naming the water inlet

Water arriving very slowly

The fastest diagnosis is the code

Open the tap fully, then check the inlet filter where the hose screws onto it — with the machine unplugged and the tap closed, because that plastic housing contains an electrical valve. In this water that filter is the single most common cause and almost nobody has ever cleaned it.

Four causes, three of them outside the machine

The manufacturer lists them in order and so do we: the tap, the inlet filter at the screw connection, a kinked hose, and flow pressure below the 7.25 psi minimum. Only the fourth is plumbing you cannot see, and only after all four does this become a valve.

Why the inlet filter matters more here

The interval this machine assumes for that filter was written for softer water than Miami-Dade, Broward and Palm Beach supply. It loads earlier, and because it sits at the tap rather than inside the appliance, almost nobody has ever looked at it.

---

**[Read full article: Dishwasher will not fill](https://mielemiami.support/symptoms/dishwasher-not-filling/)**